Drilling rig power system.

Drilling rig power system-how it works:

 Power system the power system is one of

the most important aspect of drilling

rate because it is needed to power up

our drilling rig system including rotary

system self-protect system hosting

system blowout prevention system and

monitoring system depending on the rate

horse power will have a number of engine

generator set available on the right in

this picture we have three engine set

generator this is engine set generator

number one this engine generator set

number two and this one is 

generator set number three so this

Indian generator said we'll use the

diesel fuel to operate the generator and

generator will will generate the

electricity from all these

generator set electricity is given to

power distribution system which can be

VFD our ser silicon control rectifier

our variable frequency drive ser is used

in case of red currant and VFD is you

case a poverty current if we have scr

power distribution system on the rail

then it means we will have DC motors

working with rotary table draw out TDs

our mud pumps in case if we have VFD

power distribution system on the red it

means we will have AC motors

see electric motors rotary table with

Robert with TDs and also with them what

palms so electric power from power

distribution system is then given to all

these individual rate component

including Matt Baume

tedious draw through to table he one we

will have the electric power lighting

purposes on the rig floor of the mask

will have the electric supply for the

Martin system a circulation system

similarly we will give electric power

for the minicam on the under eight where

we'll have the accommodation for

important personal will be required for

the drilling operation depending on the

nature of the operation other word

rolling we are flipping our we happen to

have some other operation it will depend

that how much we have the workload

according to that we will need the

number of engine generator we need to

keep running the maximum power required

of the rate it will be when we will go

for the hardback trimming in this

scenario while hardback remain we will

be rotating the strength with the

tedious meanwhile with a drawback we

will be who will perform in the hosting

operation as well and Markham will also

be running for the circulation so this

is the case

Elnora when will have maximum power

required to perform this operation

whereas minimum operation it will be

required when mark pump TDS draw out a

rotary table will be installed by mood

and it will happen only when will go for

wire-line operation in that case will

need minimum electric power that will be

only for power for lighting on the

masked hard area under red floor andand

on much system and the power required it

will be only for the mini mini camp as

well

it is important to note over here that

our I can have VF d dr r as we are dry

and it is also possible that Rick may

have the hybrid system I mean it may

have VFD and as he are both together

for example if mud pumps draw out rotary

table have DC motor then we will use ser

to run these these ready treatment if

tds have AC motor than we will lead VFD

to run the tedious with the AC current.